View Categories

Telematics

3 Sub Categories | 6 Docs

Device Power Modes

Last Updated: 11 July 2025

Device Operation 3rd Generation – Remote Telematics Device Date issued 11.07.2025 | Version 2.0 Topics Included 1. Device Impact on Vehicle Battery2. Airmax Device Power Modes 1. Device Impact on Vehicle Battery Under normal conditions, the Airmax device does not impact the vehicle’s battery life. Subject to the vehicle, the Airmax device uses either motion,...

LED Sequencing

Last Updated: 11 July 2025

LED Sequencing Installation and Registration The status and correct operation of the unit, both during and after registration, can be determined from the four LEDs on the unit as shown in (Fig7). Refer to Sections 9 for further instructions. The correct start up sequence is as follows: 1. Each LED will flash in sequence upon...

Antenna Mounting & Positioning

Last Updated: 10 July 2025

Mounting Equipment Quick Guide Antenna Mounting & Positioning Choosing the Mounting Location Mounting the Antenna Notes: Completing Installation 1. Secure the unit’s cable connector(Molex) to the unit using a large cable tie. Please push molex connector until it clicks and is secure. 2. Tie the cable tie around the unit from top to bottom ensuring...

Vehicle Preparation and Connection Quick Guide

Last Updated: 11 July 2025

Preparation and Connection Quick Guide 1. Ensure ignition is switched OFF prior to starting installation. 2. Locate the onboard diagnostics connector (OBD) on the vehicle which will look similar to the example shown (Fig 3). The vehicle trim will need to be removed as required to locate the vehicle’s OBD connector demonstrated (Fig. 4). 3....

Telematics Quick Guide – Step by Step

Last Updated: 10 July 2025

Telematics Quick Guide – Step by Step The following installation sequence is recommended. Please refer to the detailed instructions elsewhere in this document for further information. 1. Plan the whole installation and determine suitable locations, mouthing arrangement and cable routes for all hardware 2. Remove the vehicle OBD connector (Refer to Section 5.2 of install...

Full Product Installation Guide

Last Updated: 14 July 2025

Remote Telematics Unit Hardware Versions v3.0/3.5 Installation Guide Topics Included 1. Preface2. Safety Information3. Product Certication4. Installation Instructions5. Preparation and Connection6. Installation and Registration7. Antenna Mounting & Positioning7.1 Choosing the Mounting Location7.2 Mounting the Antenna8. Completing Installation8.1 Commissioning Installation9. Engineering Mode9.1 LED Sequence Explanations9.2 Troubleshooting10. Glossary of Terms and Abbreviations 1. Preface Failure to comply...