Preparation and Connection Quick Guide

1. Ensure ignition is switched OFF prior to starting installation.

2. Locate the onboard diagnostics connector (OBD) on the vehicle which will look similar to the example shown (Fig 3).

The vehicle trim will need to be removed as required to locate the vehicle’s OBD connector demonstrated (Fig. 4).

3. Check that the cable connector supplied is compatible to the vehicle’s connector it will replace.

4. Remove the vehicle’s OBD connector from its socket. Then fit the OBD connector supplied in its place.

5. As per sections 3.3 adhere to safety information and Identify a suitable location for the RTU.

6. Plug-in the female OBD connector supplied to the vehicle OBD connector and secure with a small cable tie (Fig 5).

7. Identify a suitable location for the antenna. It should be sited on the underside of the dashboard whilst ensuring that it, or the cable, is not fastened to removable panels or trim.

Antenna misplacement will result in unit malfunction and will be regarded as an incorrect installation Refer to sections 7 for further instructions.

8. Mount the antenna onto a position on the underside of the dash.

All mounting areas must be cleaned with the pad/wipe provided and not connected to metal surface.
Push the connectors of the antenna into their respective color matching components on the RTU (Fig 6).
Please ensure wires are clicked in place to ensure a secure connection.

9. Plug the remaining cable connector (Molex) into the RTU (Fig.6).

10. Now turn the ignition on and start the vehicle.