MaxCam – Device Installation

Topics Included

1. Safety Information
2. Installation Procedure
2.1. Route The Main Cable
2.2. Affix The Fleet Cam

1. Safety Information

This device has been tested and certified to meet the applicable limits for Radio Frequency (RF) exposure. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

For your own safety, do not operate the controls of the product while driving. Using this product does not exempt the driver from taking full responsibility for his/her driving behavior, which includes observing all traffic rules and safety regulations.

Make sure the fleet cam is positioned in a way that does not obstruct the driver’s view or airbag deployment.

Make sure that no object is blocking the camera lens and no reflective material appears near the lens. Please keep the lens clean.

Video quality may be degraded if the vehicle’s windshield is tinted.

If the car’s windshield is tinted with a reflective coating, its surface may be athermic and impact GPS reception. In this instance, please mount the device in a “clear area”.

The device will automatically calibrate its G-sensor during start-up. Always turn on the device after it is mounted in place to avoid G-sensor malfunction.

2. Installation Procedure

2.1. Route The Main Cable

Route the main cable inside the vehicle, leaving the main connector exposed at where the fleet cam is to be installed on the windshield and the other end going forward the vehicle’s power source.

TYPE II CABLE KIT:

• Use a multimeter to locate a fuse that supplies power even when the vehicle is turned off (such as the emergency hazard lights and interior/ door lights) and connect the yellow wire (B+) to the fuse.
• Use the multimeter to locate a fuse that does not supply power when the vehicle is turned off (such as the indicator lights) and connect the red wire (ACC) to the fuse.
• The black wire (GND) must be connected to the vehicle’s ground point. This product may not work properly if it is not grounded.

ALL IMAGES SHOWN ARE FOR ILLUSTRATIVE PURPOSES ONLY AND THE DRIVER FACING CAMERA IS ONLY AVAILABLE WITH MAXCAM

2.2. Affix The Fleet Cam

NOTE:

• Cleaning the windshield with rubbing alcohol before mounting the fleet cam is highly recommended.
• The double-sided adhesive tape can be replaced if it is no longer adhering to the windshield properly.
• The fleet cam should be placed near the rear-view mirror to ensure the highest video quality, but never position the device where the driver’s field of vision is blocked.

1. Peel the film off from the back of the rear plate and affix the rear plate securely onto the windshield.

2. Attach the fleet cam to the rear plate by matching the positions of the three mounting holes on the back of the camera with the hooks on the rear plate. Slide the fleet cam to the left to lock it in place.

3. Connect the main connector to the fleet cam.

4. Attach the top cover to the fleet cam and tighten the screw with an M2 hex key.